6.1 Inserting the drying agent
Remove transport mounting
The transport mounting must be removed before initial insertion of the drying agent
bag. This pipe can be subsequently disposed of.
The DULCO
®
turb C is equipped with a dehumidifying device. A drying agent bag in the
DULCO
®
turb C dries the air. The thermal discharge from the sensor is used to heat the
air. A fan mounted in the inner part of the DULCO
®
turb C circulates the warm air around
the optical sleeve and cuvette. DULCO
®
turb C continuously monitors the state of the
drying agent bag. As soon as the drying agent needs to be exchanged, this is indicated in
the lower row of the LCD display; Warning
[DESC]
(for
[Desiccant]
= drying agent).
Replacement drying agent bags can be obtained from Prominent or from your local rep‐
resentative.
Saturated drying agent can cause an alarm to be triggered, in order to indicate the
requirement for exchange. Refer to
‘Drying agent alarm’ on page 51
NOTICE!
Seal sensor housing
Possibility of premature drying agent saturation.
A damaged seal can lead to premature saturation of the drying agent.
Check the seal every time the drying agent is exchanged. Correct the seal seating or
exchange the seal if necessary.
1.
Release the screws from the corners of the housing and remove the upper part of
the DULCO
®
turb C
Commissioning
32
