SAFETY RULES
This chapter contains important safety instructions that you must follow during
operation and storage. Read the following before any operation to insure your
safety and to keep the instrument in the best possible condition.
Safety Guideline
•
General
* Do not place any heavy object on the instrument.
* Avoid severe impact or rough handling that leads to damaging the
instrument.
* Do not discharge static electricity to the instrument.
* Use only mating connectors, not bare wires, for the terminals.
* Ensure signals to the RF input do not 30dBm/±25V DC.·
* Do not block the cooling fan opening.
* Do not disassemble the instrument unless you are qualified.
* (Measurement categories) EN 61010-1:2010 specifies the measurement
categories and their requirements as follows. The instrument falls under
category II.
•
Power Supply
* AC Input voltage range: 100V~240V.
* Frequency:
50/60Hz.
* To avoid electrical shock connect the protective grounding conductor of the
AC power cord to an earth ground.
•
Cleaning
* Disconnect the power cord before cleaning.
* Use a soft cloth dampened in a solution of mild detergent and water. Do not
spray any liquid.
* Do not use chemicals containing harsh material such as benzene, toluene
and acetone.
•
Operation Environment
* Location: Indoor, no direct sunlight, dust free, almost non-conductive
pollution (Note below).
Содержание AE-366B
Страница 1: ...AE 366B SPECTRUM ANALYSER 0 MI2007...
Страница 8: ......
Страница 57: ...July 2018 3 49 Figure 48 Average Off Figure 49 Average On 8x...