REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual TEKNA ADVANCE 36
SERVICE MANUAL
ONE PIECE PLASTIC FOOTPLATE
WITH AUTOMATIC CLOSURE
REVERSING THE FOOTPLATE
1) Loosen the angle adjustment bolts
A
(grab crews
A1
and bolts
A
if ellitptical tube) and
slide off the lock and rotation sides supports from the tube and assemble them reversing
their position.
2) Or, remove the tubes, follow instructions of chapter
footplate distance
and assemble
them reversing their side.
Finally, adjust the inclinantion
and tighten the bolts
A
—
see also
“angle adjustment”
.
Using either of these two methods, you can turn the footplate position from internal to exter-
nal (or vice versa) or from 2/3 internal to 2/3 external (or vice versa).
When reversing the footplate in either these two methods, you change the lock side, too.
You can also change the position of the footplate with respect to
the rotation supports
B
.
Remove the bolt
C
of both supports. Usually, to hold the nut
C
no tool is needed, but if it turns, you can hold it using a long nose
pliers.
Assemble the footplate reversing its position on the supports
B
.
Pay attention to the correct housing for the nut
D
.
This way, you can turn the footplate position from internal to 2/3
internal (or vice versa) or from external to 2/3 external (or vice
versa).
Do not tighten the bolt
D
hard, in fact, it has to allow an easy
rotation for the automatic closure of the footplate.
B C C B
D D
B
B
V
D
A
A
A1
A
A
