REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual TEKNA ADVANCE 16
SERVICE MANUAL
REAR HEIGHT
Adjustment every 1.5 cm
You can adjust the rear height by changing the position of the
plate
A
with respect to the adjustment post.
Remove the three bolts
B
and nuts
C
and remove the plate
A
.
If a nut is close to the crossbar joint, you can let the spanner pass
between the adjustment post and the crossbar joint.
Position the plate
P
at a different height and fix it.
In order to obtain other heights, you can reverse the right plate
with left and vice versa, so that you orientate them upward or
downward.
Warning: also the receiver turns 180°, thus, if it is 2° or 4°, the
camber will result opposite! Therefore, adjust the camber/
convergence, too.
If you decrease the rear height, remove the side guard first. In
fact, the rear wheel will touch the side guard.
After adjustment, adjust the side guard and the brake, too.
Remember that the adjustment of the rear height affect the seat
inclination, therefore it is necessary to check/adjust the fork an-
gle, too.
Info
: the bolts
B
are made-to-measure. That is necessary to pre-
vent interference between the point of that bolt and the crossbar
rotation tube where this would happen with longer (even 1 mm)
bolts
.
A
B
C
Spanner between
crossbar joint and post.
Plate orientated upward and
assembled in the highest
possible position
(minimum rear height
.
