Disarm: defense zone 1~99 will not alarm when detector triggered
(except 24 hours defense zone)
System setup status: In this status, all defense zones will not alarm
when detectors are triggered.
2.Remote Controller Operation
Users can use remote controller to set system as Out Arm, Home Arm,
Emergency Alarm, Real-time Disarm and etc.
Out Arm: Press button
Disarm: Press button
Home Arm: Press button
Emergency Alarm: Press button, system will alarm at once.
Operating Instructions
LCD display:
4.Home Arm
It means, for the safety, while somebody is at home, you need to
enable the peripheral door, window, balcony and boundary detectors of
the alarm system while prevent from triggering the indoor detectors,
which may cause improper warning; then, you shall select Arm at
Home, let just part of the detectors work and disable the other parts.
Main unit Operation: Press [STAY ] button on keypad
Remote Control Operation: Press [ ] button on remote controller once
LCD display:
19
20
Operating Instructions
3.Out Arm
It means to guard all around your house while everyone is going out;
all the detectors of the host are always working; when the detector is
triggered by detecting source (anti-theft, fire prevention, gas leak, etc.),
the alarm system will sound the alarm.
Press [ARM ] button on keypad, system will make a beep per second
and totally 60 beeps. The [ARM] indicator will be on without flashing. It
means Out Arm is set successfully.
Main unit operation: Press [ARM ] button, the system will enter arm
status 60seconds later or delay time set by user
Remote controller operation: Press button on remote controller,
system will enter OUT ARM mode immediately.
SMS remote operation: The SMS command is: Remote Control
Password (Default: 1234) + [1]
After the setting, the host makes a "Di" sound, ARM LED is on and you
will receive a SMS: System armed.
Note: SMS command can only be controlled by the preset three alarm
SMS numbers.
20
5.Disarm
It means to stop the alarm when the main unit sounds the alarm or
make the alarm system in the state of non-warning. After disarming,
even if you trigger the detector, the main unit would not sound alarm
(excluding 24-hour defense areas).
Use keypad to input system password (Default: 1234), then press #
button. [ARM] or [STAY] lights will be off. It means disarm setting
successful.
Main Unit Operation: input system pa #
Remote Control Operation: Press [ ] button on remote controller
SMS remote operation: The SMS command is: Remote Control
Password (Default: 1234) + [2]
After the setting, the host makes "Di" Di" sound, ARM LED is off and
you will receive a SMS: System disarmed.
