Profibus AEV-70, Руководство по программированию

Страница: 94 / 131

Parameterization and configuration
TR-Electronic GmbH 2011, All Rights Reserved Printed in the Federal Republic of Germany
Page 94 of 131 TR - ECE - BA - DGB - 0089 - 01 10/24/2011
7.1 Overview
Configuration Operating parameters *·
Length Features
PNO Class 1
Page 95
- Count direction
16 bit IN
- No measuring system scaling, the measuring
system has the base resolution according to the
nameplate
- 16 byte diagnosis data
- Count direction
PNO Class 1
Page 96
- Count direction 32 bit IN
PNO Class 2
Page 97
- Count direction
- Class 2 on/off
- Commissioning diagnostics
- Scaling function
- Steps per revolution
- Total measuring range
16 bit IN
16 bit OUT
- Max. steps per revolution
≤ 8192, if higher
resolutions are required, one of the TR-Modes
must be used
- Measuring system scaling is possible, however
the number of steps / revolution must be an
integer and the number of revolutions an
exponent of 2
- Preset adjustment via the bus
- Count direction
PNO Class 2
Page 99
- Count direction
- Class 2 on/off
- Commissioning diagnostics
- Scaling function
- Steps per revolution
- Total measuring range
32 bit IN
32 bit OUT
TR-Mode ,
Position
Page 101
- Count direction
- Commissioning diagnostics
- Short Diagnostics
- Total measuring range
- Revolutions numerator
- Revolutions denominator
- Code PROFIBUS-Interface
- Lower limit switch
- Upper limit switch
32 bit IN
32 bit OUT
- Measuring system scaling possible, the number
of steps per revolution can be a decimal number
and the number of revolutions any number (not a
exponent of 2).
- Preset adjustment via the bus
- Count direction
- Output code programming
- Soft limit switch function
TR-Mode ,
- Po
- Velocity
Page 105
- Count direction
- Commissioning diagnostics
- Short Diagnostics
- Total measuring range
- Revolutions numerator
- Revolutions denominator
- Code PROFIBUS-Interface
- Lower limit switch
- Upper limit switch
- Velocity
32 bit IN
16 bit IN
32 bit OUT
- Measuring system scaling possible, the number
of steps per revolution can be a decimal number
and the number of revolutions any number (not a
exponent of 2).
- Preset adjustment via the bus
- Count direction
- Output code programming
- Soft limit switch function
- Velocity output
*
from the bus master perspective