Optional Units and Expansion Boards
PL-5700 Series User’s Manual
3-12
• To prevent short circuits with the expansion
board inserted in the slot, use only the plastic
screws which came with the PL-FD001 to
mount the FDD unit on the rear maintenance
cover.
• Be careful not to pinch the cable between the
PL body and FDD unit. This may damage the
cable.
• If the cable is too long or contacts the 100
VAC input terminals and AC power cord, se-
cure the cable with the PL-FD001’s cable
clamps.
• When installing the PL-MC000,
keep the cable away from the memory
card’s interface. Otherwise, the
memory card cannot be installed.
2. Insert the PL-FD001 cable into the FDD connec-
tor.
3. Use the four plastic screws which came with the
FDD connector to attach the PL-FD001 to the
PL’s rear maintenance cover.
4. Take the PL-FD001 cable out as shown in the
figure, and slide the dummy unit or optional PL-
MC000 toward the front panel to set it in place.
Then, tighten the six attachment screws on the
PL’s side and bottom panels.
Side panel of the PL
Remove
the dummy unit
FDD connector
Rear maintenance
cover
PL-FD001
