Pro-Line Boats 35 Express 2006, Руководство пользователя

Страница: 45 / 95

38
the automatic float is operating properly. It is recommended that you check the operation of each
automatic float switch monthly.
High Water Alarm
A high water alarm switch is mounted on the console and is
wired to bilge pump 2. The switch should be kept in the
“Auto Alarm” position (to the left). When the automatic float
switch activates bilge pump 2, the alarm will sound. If the
alarm should sound, as a precaution, check the bilge area
immediately to determine if emergency action should be
taken. The toggle switch may be turned to the override
position (to the right) to deactivate the alarm.
Fish Boxes with Macerator Pump
Your boat is equipped with port and starboard fish boxes
with a total capacity of 125 gallons. The 6.5 macerator
pump drains both fish boxes and/or macerates any fish
particles. The pump is located in the bilge and is equipped
with an automatic float switch. As the fish boxes drain,
water and/or debris travel to the holding tank attached to
the pump and then to the fish box macerator pump which
pumps the water and/or debris overboard.
The fish box macerator pump operates on a 2-way rocker switch located on the switch panel labeled fish
box. To properly operate the fish box macerator pump, fill both fish boxes with water. Then move the fish
box switch on the switch panel to the forward position to operate the pump. The water and fish particles
will be pumped out of the tubs and will be routed through the macerator pump and then overboard via the
fish box thru hulls on each side of the boat. When you are finished emptying the fish boxes, place the fish
box switch in the aft position to turn off the fish box macerator pump.
To check the system for drainage, remove the white 90
o
elbow fitting that connects the hose to the
holding tank. The fitting is held in place with a rubber grommet therefore no hose clamps need to be
removed. After removing the fitting, feel around just inside the holding tank for the 2 round plastic buttons
(approx. ½” in diameter) and simply lift the 2 buttons to check the operation. If the float is working
properly, the pump will activate. On occasion, you may find excessive debris in the holding tank that is
causing a blockage. Just remove the debris through this same opening. When you are finished checking
the operation, reinsert the 90
o
elbow fitting back into the rubber grommet until is seats itself.
Bilge 1
Bilge 2 - This
pump is wired to
the High Water
Alarm.
Float Switches
Forward Bilge Pump
w/Float Switch