Pro-Line Boats 35 Express 2006, Руководство пользователя

Страница: 26 / 95

19
A tripped breaker will protrude or move from its set position indicating that the circuit has been
overloaded. Turn off the device(s) on the circuit, then reset the breaker by pushing in once or by
returning a breaker switch to the “ON” position. If the breaker does not reset or if it resets and then trips
again after the device is turned back on, then a short circuit exists or your device may be damaged,
overloaded, or faulty. Correct the problem and then reset the breaker.
Circuit Breakers – On the switch panel above the individual switches
If the breaker continues to trip and you are certain the device, switch and wiring are in good repair; either
the breaker is faulty or it is too small for the load. Reduce the load or replace the breaker.
Blower
The blower (standard with the optional generator) is located inside the
bilge and helps keep fresh air circulating in the bilge area. You should
periodically check to make sure that the blower is working properly.
First, confirm that the blower hoses are connected and the blower itself
is secured. Second, locate the blower switch inside the cabin on the
starboard cabin wall and press the switch to the on position. Then, go
back to the bilge area and listen to hear if the blower is running. The
exhaust vents are located on the outside of the transom on the port and
starboard sides. Check to ensure that air is blowing out of the vents.
When finished, go back into the cabin and turn the blower switch off.
Gas Generator w/Carbon Monoxide Detector (Optional)
If you have selected the optional generator, your vessel will come equipped with a remote start/stop for
the generator, an hour meter and a blower switch.
Blower
Exhaust
Vent
Blower
Switch