Pro-Line Boats 35 Express 2006, Руководство пользователя

Страница: 27 / 95

20
WARNING: The switch for the blower is installed next to the AC/DC panel and should be
turned on for four (4) minutes prior to starting your engines or the generator to ensure
that the bilge is free from any gas fumes. The blower vents are located on the inside
wings of the Euro transom/dive platform.
The generator is installed in the aft area of the bilge and it can be started either direct from the generator
or remotely from the AC panel in the cabin.
Before attempting to operate the generator, the boat must be in the water or have some type of water
flushing system going into the generator water pick up. The generator seacock is mounted below the port
side hatch on the berth of the mid cabin. Inspect the seacock and ensure that it is open and that the
hoses are all connected. The seacock is open when the lever is in the vertical position.
Starting the Generator from the Main Unit - You can start the unit directly from the generator
using the mechanism in the black box located on the upper port side of the generator.
•
At the remote control panel for the battery
management system (installed on the
console), press the house battery switch
forward to the on position
•
Go into the cabin, locate the AC/DC panel
and move the generator toggle switch to
the on position.
•
Locate the blower switch (installed next to
the AC/DC panel) and turn it on. After
allowing the blower to run for a few minutes
and circulate fresh air throughout the bilge,
the generator can be started up.
•
Flip the start/stop switch, which is located
on the black box on the front of the
generator, to the “start” position. This
black box also houses an hour meter,
fuses and an AC Circuit breaker.
•
To turn the generator off, flip the start/stop
switch to the “stop” position
Generator
Generator
Seacock
Shown in the
Closed Position
Generator
Black Box