36
Once the tank level reaches the “low” level in the tank, the green light will go out and the system will turn off. You
will need to turn the key to the “manual” position to complete the pump out process.
If the system does not seem to be pumping properly (water should shoot out approx. 10 feet via the thru hull),
check for leaks, loose clamps, etc.
For limited access to hose connections, remove the tackle box and frame by removing only the top 2 and bottom
2 screws of the tackle box. The other 4 screws hold the frame to the tackle box. Check the hose connections to
be sure that there is no leak. Then, lift the hinged hatch on the bottom of the mid berth and check the fittings
and/or clamps on the pump. For full access to hose connections, remove the port side wall inside the mid berth.
Refer to the manual in your owner's packet supplied by the manufacturer of the VacuFlush system for specific
operating instructions.
Dockside Discharge – The stainless steel dockside discharge waste outlet is labeled waste is located amidships
on the port gunwale. Twist the cap to open the fitting and connect to your marina’s dockside service facilities.
When at a marina that offers dockside discharge, the marina will provide the facilities needed to perform this
operation. You will not need to use the Tank Watch system. The stainless steel fitting labeled waste is located
amidships on the port gunwale. Twist the cap to open the fitting and insert the hose provided by the marina into
the dockside discharge waste outlet to connect to your marina’s dockside service facilities. Follow the instructions
provided by the marina to operate their equipment.
Warning: Waste in the holding tank can form methane, an explosive gas. Use suitable precautions when any
maintenance is done to the sanitary system.
Fuel/Oil Systems
Fuel Tank
Standard Fuel Tank - The 320-gallon fuel tank on your Pro-Line is constructed of heavy gauge aluminum with
internal baffling to minimize sloshing. The fuel tank is located under the deck and is secured between the
stringers and bulkheads. For access to the fuel sender and fuel pick-ups, lift the bilge hatch, then remove the
oval access pie that is secured with 6 screws.
You should inspect the hose connections on a regular basis. For access the fuel fill and fuel vent hoses:
For access to the hose connections at the fuel tank, open the cockpit storage hatch located
between the lounge and helm seats. Then, remove the round access pie that is installed on the
aft wall of the storage compartment.
For access to the hose connections at the stainless steel fuel fill and fuel vent fittings, remove the
starboard wall of the cockpit storage compartment.
Starboard
Engine Pick-up
Manufacturer’s
Label
Generator Fuel Pick-up
Fuel
Sender
Port Engine
Fuel Pick-up
