Lume n 200/S/P r o
™
19
4.2
Installing your system.
4.2.1 Installing the Bulb
Required equipment:
Lumen200S, Hex Key, Prior LM200B1-A Bulb
Warning:
•
Only use Prior LM200B1-A bulbs, failure to do so may cause damage to the unit.
•
Do not touch the inside of the reflector of the bulb.
•
The bulb is delicate, handle with care.
Instructions:
1.
Disconnect the Lumen200S from the mains supply,
(If the Lumen200S has been previously
switched on, wait for 30 mins to allow bulb to cool)
.
2.
Find a flat surface and place the lumen upside down on the surface.
3.
Unscrew the four Hex screws and remove the panel, as indicated in Figure 11 below.
Fig 11- Bulb housing
.
Hex Screws
