Lume n 200/S/P r o
™
39
5.2.3 Connecting your Lumen200Pro to a OptiScan or ProScan System
The Lumen200Pro requires two filter wheel connections to a ProScan II or OptiScan II system.
Connecting your system:
1
Switch off the ProScan or OptiScan II controller.
2.
Connect Filter Wheel, Shutter port and Lamp ON/OFF (Optional) on the Lumen to the
Filter 1 and Filter 2 and Shutter port on the ProScan or OptiScan II system using the cables
provided.
a.
It is not important which Filter connections are used on the Controller, but this
should be noted for use with the command set described below, and for any 3
rd
party
software .
b.
Tighten the screws to fix the cables in position.
3.
Switch on the Controller, your Lumen200Pro is now ready to accept commands.
a.
It is not necessary to switch the Lumen200Pro power on to control the Shutter and
Filter Wheel, these are powered by the attached controller.
Fig 31 - Controller attachments for Lumen 200Pro.
Filter Wheel
Light
Attenuator/Shutter
Lamp on/off
Fuse
Power Socket