5
3. Replace Original Peel/Tear Door Assembly
1. Open the pivoting deck on the printer by rotating the deck lock lever fully clockwise. Remove the two thumbscrews
on the existing Peel/Tear Door assembly and remove the assembly from the printer and set it aside.
Figure 1:
Open Deck Locking Lever, remove Peel/Tear plate
2. Install the ODV2D-V2 Peel/Tear Door Assembly, provided in the kit, to the front of the printer. Secure the door to the
printer with the two M5x16mm thumb screws provided. Bias the door downwards while tightening the screws.
Figure 2:
Install new Peel/Tear plate using thumb screws provided
4. Install ODV2D-V2 Interface PCBA and Cable
1. Use a 2.5mm hex key to loosen the three captive screws securing the frame side cover.
2. Tilt the side cover out from the top and lift it up until the tabs along the lower edge disengage from the slots in the
base of the printer.
Deck Lock Lever
M5x16mm
Thumb Screws
Figure 3: Removing the Frame Side Cover
