15
5. Place the bubble level edge of the 6 inch square on the same flat surface that the printer is on and note the
position of the bubble.
Figure 19:
Bubble Level Adjustment
NOTE:
The bubble may NOT be centered in the level. It is not necessary that the table, the printer or the ODV2D be
perfectly level, only that the angles of these surfaces be match.
Figure 20:
ODV2D-V2 Bubble Level Adjustment
6. Next rest the square on the top surface of the ODV2D-V2. The bubble should be at the same position as noted in
step 5.
Bubble Level
