Printek PrintMaster 860, Руководство оператора

Страница: 13 / 75

G E T T I N G S T A R T E D
Note: DO NOT take up the ribbon slack or
reposition noseshield after seating cassette.
The printer will do his automatically when the
ribbon cover is closed.
Close lid and put printer ONLINE to
automatically tension the ribbon.
Loading Paper
When shipped from the factory, the basic configuration for all ten forms is an eleven-inch form, six lines
per inch, and ten characters per inch. If the forms you are loading do not match these requirements, please
refer to the printer Configuration” chapter on page 19 and review the “
Introduction To Setup
” and “
Forms
Menu
” sections.
Please refer to the appropriate section below for loading paper in the PrintMaster 860 or PrintMaster 862.
PrintMaster 860 Single Tractor Model
Loading the Form in the Tractors
1. Open the paper door (rear lid) of the printer. This will provide access to the tractors as shown below.
Rear Feed Tractors
2. Open the tractor doors and remove the old form.
3. If the new form is a different width than the previous form, unlock the right tractor and move it to
approximately the new position.
Note: The left tractor position is fixed and may not be moved.
7