Price FFU series, Инструкция по установке и обслуживанию

Страница: 11 / 42

FAN FILTER UNIT
INSTALLATION INSTRUCTIONS
Step 2: If using potentiometer/manual adjustment, rotate the potentiometer (POT/DIAL) dial on the outside of the box with a
screwdriver until the test point voltage is achieved.
NOTE: ECM Speed Controllers have 2 modes: manual adjust and BAS (Building Automation System). Standard manual control
outputs are shown below:
Measurement Tab Voltage Motor Control
0 - 1 VDC Off
1 - 4.5 VDC 0-100%
4.5 - 5 VDC 100%
The speed controller will automatically ignore the potentiometer (POT/DIAL) when a BAS signal is detected (BAS Input Signal >1).
VDC equations are for potentiometer (POT/DIAL) manual adjustment only (0-1 BAS input signal). The VDC equations are based
on a 1-5 Volt scale. The BAS input voltage is a 2-10 VDC scale, and therefore VDC calculated for a given CFM using the equation
must be doubled to achieve that CFM using the BAS input.
BAS Voltage Response Notes
0 - 1 VDC Local control mode using push buttons Local setpoint can be adjusted from 0 - 100% using push buttons
1 - 2 VDC Motor Off Recommended sending a 1.5 VDC signal to command motor off
2 - 10 VDC Modulating Control 2 - 10 VDC modulates motor in accordance with VDC equations
Example: If using a BAS signal, to calculate appropriate starting voltage, first calculate the VDC (as shown in above example)
VDC = 2.44 V
Then double this value
BAS Input Voltage = VDC*2
BAS Input Voltage = 2.44*2
BAS Input Voltage = 4.88V
Step 3: Wait a few seconds for the ECM motor to adjust its speed and then verify fan airflow with measurements at the unit face
using a flow hood. Adjust the POT/DIAL, or BAS input signal to reach desired airflow as required.
Step 4: Proceed to balancing section of this manual.
SPEED CONTROLLER ADJUSTMENT
POTENTIOMETER/
DIAL ADJUST
GREEN STATUS LED
MUST BE BLINKING.
(CODE 1 THRU 4)
9
priceindustries.com | FAN FILTER UNIT - Manual