PREVOST X3-45 2011, Руководство оператора

Страница: 92 / 214

Controls and Instruments 86
The following gears are available:
Forward driving - 1, 3 & 5
Reverse driving - R1
To select the reverse driving in Limp Home
mode, simply select position R. Gear changing
can only be done while the vehicle is stationary.
To Deactivate the Limp Home Mode
The Limp Home Mode will be deactivated when
the ignition is turned off.
STARTING AND STOPPING
Starting
The pushbutton shift selector must be in the N
position or the engine will not start. If the
pushbutton shift selector is not in neutral, a
starter protection message will appear in the
DID along with the INFORMATION telltale and
an audible warning.
If there is not enough air pressure in the I-Shift
air tank, a low air supply message will appear in
the DID along with the INFORMATION telltale
light and an audible warning. Start the engine
and allow the air pressure to build in the tank.
Wait until the message and the telltale light turn
off before attempting to shift the transmission
into gear.
The brake pedal must be pressed down when
passing from the N position to another position
otherwise pressing the buttons will have no
effects.
Stopping
When parking the vehicle, always apply the
parking brake and place the pushbutton shift
selector to the N position. Make sure the
parking brake is holding the vehicle before
leaving the driver position. Failure to do so can
result in unexpected vehicle movement and can
cause serious personal injury or death.
When the vehicle is stopped:
1. Apply the parking brake.
2. Select the N position on the pushbutton shift
selector.
3. Turn off the engine.
STARTING THE VEHICLE UPHILL AND
DOWNHILL
Hilly Operating Conditions
When starting the vehicle on an uphill slope:
1. Press the brake pedal.
2. Select the D position on pushbutton shift
selector. The driver can use the – button to
select a lower start gear if wanted.
3. Quickly move your foot from the brake pedal
and completely depress the accelerator
pedal.
CAUTION
Always use the brakes to hold the vehicle
stationary on an uphill stop. Never hold the
vehicle stationary on an uphill slope using the
accelerator pedal. The clutch could overheat,
which could cause it to breakdown.
The I-Shift transmission clutch is a dry disc
type, with
no torque converter . Never allow
the clutch to slip in a too high gear when
starting the vehicle. If the clutch overheats, a
high clutch load message or clutch protection
active message will appear in the DID along
with the CHECK telltale light and an audible
warning.
DANGER
The vehicle can roll when stopped on a hill or
grade, or when the vehicle is starting from a
stop on a hill or grade. Always use the brakes
to hold the vehicle stationary on a hill or
grade. Failure to do so can result in serious
personal injury or death.
Hill Start Assist
Hill Start Assist provides anti-roll assistance
during the transition from standing still to starting
on a grade. The brake system maintains pres-
sure in the brake chambers for 3 seconds after
the service brake pedal is released, which al-
lows time to the driver to move is foot from the
brake pedal to the accelerator pedal.