44
6
Digital Effects | Master Control
6.2 Scenes
StudioLive™ 16.0.2 USB
Owner’s Manual
6.2
Scenes
The StudioLive allows you to create and store a library of Scenes. A Scene is like
a snapshot of your mix. It stores each Fat Channel parameter for every input
and bus, as well as each fader’s position, the aux and effects mixes, channel
mutes and solos, and the input source (analog input or USB playback stream).
6.2.1
S1: Zero Out (Board Reset)
Located at position S1 is a scene named Zero Out (Board Reset). This scene cannot
be overwritten and returns each parameter to its default setting. All you have to
do is lower the faders and return all trim knobs and output volume knobs (Solo
bus, FX A and FX B Output, Phones, and Monitor) to their lowest positions.
The StudioLive will be zeroed out as follows:
SETTINGS
INPUTS AND BUSES
OUTPUT LEVEL
ASSIGN
PAN
SOLO
MUTE
STEREO LINK
INPUT CHANNELS
NULL
MAINS
C
OFF
OFF
OFF
AUX BUSES
NULL
N/A
N/A
OFF
N/A
OFF
FX A / FX B
NULL
MAINS
N/A
N/A
OFF
N/A
AUX IN A/B
NULL
MAINS
N/A
N/A
N/A
N/A
SOLO BUS
NULL
N/A
N/A
N/A
N/A
N/A
MONITOR BUS
NULL
N/A
N/A
N/A
N/A
N/A
The Fat Channel will be restored to the same setting for every
input and output on your StudioLive. Each of the dynamics
processors and the three bands of the EQ will be turned off.
Their parameters will be set as follows:
FAT CHANNEL PARAMETERS
HIPASS
NOISE GATE
LIMIT
COMPRESSOR
EQ
LOW
MID
HIGH
STATE: OFF
STATE: OFF
STATE: OFF
STATE: OFF
STATE:
OFF
OFF
OFF
THR
75 Hz
THR
-84 dB
THR
0 dB
P/S
PEAK
N/A
PEAK
RAT
2:1
H/L
N/A
LOW
N/A
RESP
MED
FREQ
130 Hz
96 Hz
5 kHz
GAIN
0 dB
GAIN
0 dB
0 dB
0 dB
Power User Tip:
Before beginning any new mixing situation, it is always recommended to
recall the Zero Out (Board Reset) Scene. This is the easiest way to ensure that there are no
lingering parameter settings that could cause you some trouble in your new mix.
6.2.2
Creating a Scene
Creating a Scene requires simply dialing in a mix that you would like to
use later and saving it. This has obvious benefits for both studio and live
sound. For example, in the studio, saving and recalling a Scene allows you
to move to another song or project and come back to the current mix later.
For live shows with multiple bands, you can set up custom mixes for each
band at sound check and recall the mix when that band goes onstage.
