Precor AMT 823, Руководство по обслуживанию

Страница: 48 / 400

© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 46
4
Access the diagnostic program, per procedures
Accessing the P30
Diagnostic Software
(on page 13),
P80 Settings
(on page 51), or Accessing
the Diagnostic Software. Advance to the heart rate display portion
of the diagnostic program. Verify that a hand held signal is not
being accepted by firmly grasping both the right and left hand held
contacts on the handlebars. Cover as much of the top and bottom
contact surface area with your hands as possible (without moving
your hands), you should receive a heart rate reading within ten
seconds.
5
If the hand held signal is now being accepted, something in the near
vicinity is radiating RF (radio frequency) energy that is being
received by the chest strap portion of the heart rate PCA.
6
If a hand held signal still not being accepted, skip to step 8.
7
Replace the heart rate PCA with a 300812-101 (or higher) heart rate
PCA. 300812-101 and higher versions of heart rate PCA are less
susceptible to radiated RF energy.
8
Access the diagnostic program, per procedures
Accessing the P30
Diagnostic Software
(on page 13),
P80 Settings
(on page 51), or Accessing
the Diagnostic Software. Advance to the heart rate display portion
of the diagnostic program. Verify that a hand held signal is not
being accepted by firmly grasping both the right and left hand held
contacts with the opposite hands, right hand on the left handlebar
contacts and left hand on the right handlebar contacts. Cover as
much of the top and bottom contact surface area with your hands as
possible, you should receive a heart rate reading within ten
seconds. If a hand held signal is still not being accepted, skip to
step 10.
9
If a hand held signal was accepted in step 8, the hand held contact
wiring is reversed. The harness that connects to the hand held
contacts in the handlebar is segregated into two groups. One group
has blue shrink wrap around it and the other group has black shrink
wrap around it. The blue group must go to the right hand contacts
and the black group must go to the left hand contacts. If necessary,
rewire the hand held contacts as described above and test as
described in step 4.