Precor AMT 823, Руководство по обслуживанию

Страница: 259 / 400

© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 257
13
With assistance, lift the front arm out of the lower main shaft
clamp and upper arm, gently set the front arm on a flat work
surface.
Note: On April 3, 2013 the front arms and cams were redesigned so that
the cams are pressed onto the front arm axle. If you are servicing a
AMT12 that has this configuration, skip the cam removal steps.
Important: Before removing the cams, note the orientation on the front arm.
1
Mark the sides of the inside and outside cams with a notation to
indicate the sides facing away from the front arm tube. For example,
mark the outside cam with a "O" and the inside with a "I".
Figure 193: Front Arm Cam Orientation
Note: Any time the flat belt terminal screws are removed from the flat belt
clamp or cams, the screws must be discarded and replaced with new
screws.
2
Remove and discard the four screws and shims that secure the two
flat belt cams to the front arm tube, slide the cams off the front
arm tube.
3
Remove the two square keys that align the cam to the front arm tube.