4
code=homeal,fs
- firmware start
In the description of the zones must not contain commas (,).
At read command of configuring parameters, finally after the GSM
number must be a period (.).
the length of the sMs does not have to be more than 00 characters. Keep in
mind that when sending an sMs on the internet the operators add advertising, texts
that increase the length of the message. so when configuring via the internet it is bet-
ter to send less commands.
Instructions for commissioning
. fill in the table of parameters of the protected object. Most of the values
are entered by default, but must be defined:
- depending on the designation of the zones for each of them is filled the fields
for a type of zone: delayed, instant, 4-hr., interior or for arming; by default is zone
is delayed, zones -4 are instant, zone 5 is 4-hr., zone 6 is for arming;
- depending on the method of wiring of the zones for each of them are filled
the fields for the active state and for balance of the sensors (see the figure "Variants
of connecting zones"): normally open or closed contact, balanced or unbalanced,
with tamper or without tamper, paired or single; by default, all zones are with normally
open contact;
- GsM numbers for communication;
- other parameters is also good to be further determined according to the
needs.
. the panel is configured via Pc or via sMs:
3. Mount the circuit board in the box and with disconnected power connect the
zones, the siren and the remote led indicators.
4. insert the siM card, on which must first be removed the Pin code and
erased all sMs-es.
5. Where necessary to test the zones, before turning on the power to the
panel must be installed a jumper between terminals "Y" and "G". see "test of the
zones."
6. connect the power supply ~ 0V. should light the led "Power". the leds
"", "4", "8" and "6" light up briefly and go out, and then for about 5 seconds, lights
the led "status".
7. connect the battery.
8. Wait for connecting the panel to the GsM network of the operator. see
"led indication". after a successful connection, the led "GsM" should light up briefly
every 3 seconds. led "status" should not blink.
