11
III.3 Starting the Machine
1.
Connect the line cord to a 220 - 240 VAC, 1 Phase power source. Turn on the
Safety Disconnect Switch on the left side of the machine. Using the proper
key, make certain the
[EMERGENCY STOP]
button is not locked in. Press
the green [
On
] button (designated on the button by the numeral
I
).
2.
The power indicator (between the green and red buttons) will light.
3.
After the touchscreen initializes, the following Operations screen will then
appear:
F
IG
.
4:
O
PERATIONS
S
CREEN
This screen shows the machine’s operational status at a glance and contains all
necessary controls to run automatic cleaning cycles.
The [
TEMP (F)
] indicator reports the measured temperature of the cleaning fluid in
degrees Fahrenheit.
The [
TEMP STATUS
] indicator reflects the conditions of the indicators on the
“Fluid Temperature” Screen. If the fluid temperature is either low or high, this
indicator will display [
LO/HI
]. This condition does not prevent operation.
The [
CYCLE SELECT
] Pushbutton allows the user to select either the
[PASTE]
Cycle or the
[GLUE]
Cycle. Each of these is independently programmable for any
desired length of time.
