Powerhorse 74006, Руководство пользователя

Страница: 41 / 68

Operation
41
7.
AC Parallel Operation
AC parallel operation allows the connection between two 7500i Powerhorse generators to increase available
power. The parallel cable is not included with the generator but is available as Parallel Cable Kit item # 157247
and can be purchased from Northern Tool + Equipment.
Before connecting an appliance while paralleling generators, you must:
•
Make sure that the appliance is in good working order.
•
Verify the appliance electrical rating does not exceed that of the receptacle.
•
Ensure that each generator is individually grounded. See Installation/Initial Set-up section.
•
Ensure that the ESC throttle switch is in the MAX position on both generators.
•
Ensure that the voltage selector switch is in the 120V/240V position on both generators.
•
Make sure all devices that were connected to the generator’s outlets have been disconnected.
Note: Most motorized appliances require more than their electrical rating for start-up. When an electrical motor
is started, the overload indicator (red light) may come on. This is normal if the overload indicator (red light)
goes off within 4 seconds. If the overload indicator (red light) stays on, contact Powerhorse Product Support at
1-866-443-2576.
WARNING:
Do not install or use the Parallel Kit when there is an exposure to water such as rain.
WARNING:
Turn off both generators before installing the Parallel Kit.