Powerhorse 74006, Руководство пользователя

Страница: 40 / 68

Operation
40
6. Stopping the Generator
Stop the engine using the following steps:
1. Disconnect any loads.
2. Turn the ESC switch
1
to “ STANDARD ” , if applicable.
3. Turn the Main Switch to “OFF” .
a) Ignition circuit is switched OFF.
b) Fuel is switched OFF.
5. Connecting Loads
Be careful when connecting loads so as not to overload the generator, especially if you are powering devices
with motors that require a higher starting power load.
Instructions are provided below for connecting loads when you are using the generator:
o
As a portable power source
o
When connecting to a building as a back-up power source
WARNING:
Do not overload generator. Make sure that combined starting and running
loads do not exceed rated capacity of generator. Overloading the generator can cause
damage to the generator and attached electrical devices, and may result in fire.
Using as a
Portable Power
Source Connect electrical loads one at a time using the following instructions:
1. Allow engine to reach operating speed by allowing it to warm up for
approximately 5 minutes before connecting electrical devices.
2. After engine is warmed up, begin by connecting the items that require the
highest wattage first. The recommended sequence is as follows:
a. Connect items with motors such as refrigerators, freezers, air conditioners,
or small hand tools, one at a time. Let each motor stabilize before
connecting the next device.
b. Connect any lights you are planning on powering.
c. Connect voltage sensitive equipment such as electronics via surge
protectors. Plug devices such as TVs, computers, and microwaves into a
UL listed voltage surge protector, then plug the surge protector into the
generator.
Using as a
Back-up Power
Source for a Building
Each transfer switch installation will be unique.
Proper instructions to safely connect the generator online with the building’s
electrical system should be provided by the installing electrician, who should also
provide personal instruction to the owner/operator.
Failure to follow the proper procedure as provided by the electrician could expose
persons to the hazards noted above.