Powerhorse 74006, Руководство пользователя

Страница: 17 / 68

Machine Component Identification
17
Low Oil Warning
Light When the oil level falls below the lower level, the oil warning indicator
1
lights up
and the engine stops automatically. The engine will not start again until oil has been
added.
Note: If the engine stalls or d oes not start, turn the engine switch to “ON” and then
pull the recoil starter. If the oil warning light flickers for a few seconds, the engine oil
is insufficient; add oil and restart.
Overload/Fault
Indicator Light (Red) The overload (fault) indicator light
1
comes on when an overload of a connected
electrical device is detected, the inverter control unit overheats, or the AC output
voltage rises. The AC circuit breaker will trip, stopping power generation to protect
the generator and any connected electric devices. The output indicator light (green)
will go off and the overload (fault) indicator light (red) will stay on but the engine
does not stop running. When the overload indicator light comes on and power
generation stops, proceed as follows:
1) Turn off any connected electric devices and stop the engine.
2) Reduce the total wattage of connected electric devices within the rated
output.
3) Check for blockages in the cooling air inlet and around the control unit. If any
blockages are found, remove.
4) After checking, restart the engine.
Note: The overload (fault) indicator light may come on for a few seconds at first when using
electric devices that require a large starting current, such as a compressor or a submersible
pump. However, this is not a malfunction.
Output Indicator
Light (Green)
The Output Indicator
1
lights up when the engine starts and produces power.