Operation and installation manual
Page 38 of 96
(PVI-STRINGCOMB (-S, -MC, -S-MC) - Rev:1.0)
9.2 Positioning
The device should normally be positioned with the wire input/output
sockets at a low position: no other position is admitted.
The only purpose of the cable glands is to prevent water from entering
the container. They must absolutely not support the weight of the wires.
It is therefore necessary to provide for a system to support the weight of
the wires.
The figures below also show the position of the mounting holes and a possible
solution for supporting the wires (see detail SC in Figure 9-2 and the Figure 9-3
as an example of complete use).
Access to the holes is possible only by removing the cover. The holes
indicated by the dotted arrow need not necessarily be used (the installer
must assess the strength of the support and/or the type of anchorage
used).
Figure 9-2: Positioning of the box and an example of wire support
P
SC
