0600-GB ANBAU_987
GB
ATTACHING TO THE TRACTOR
- 8 -
TD65/92/27
1
P1
P2
Parking stand
- Using the control lever
(8), release parking
stand, swing up and
back and lay in the clamp
(9).
Lighting and Warning equipment
When travelling in fog, half-light or at night, protruding parts are to be
clearly indicated. Advice on the application of warning signs, reflective
film or paint and lighting units can be found in the instructions for
ancillary equipment in supplement C.
PôTTINGER can supply lighting units and warning signs upon
request.
Always observe the
statutory regulations.
Removal from tractor
Hint:
The shear points are hardened so when set down onto hard surface
(stone, concrete, etc.), risk of breaking exists. Therefore lower the
shear points onto a suitable support (wooden board)!
- Turn plough frame to working position and park the implement on
stable and even ground.
- Move the control lever (ST)
back and forth several times
to reduce pressure in the
hydraulic lines.
- Switch tractor’s hydraulics
to control position.
- Disconnect hydraulic hoses
from tractor.
- Using the control lever
(8), release parking stand,
swing down and secure.
- Detach upper and lower links from implement.
Garaging, cleaning and winter storage of the
implement
• Observe the points in the chapter „MAINTENANCE AND
SERVICE“!
8
9
TD65/92/31
Attaching to the tractor
Safety advice:
See supplement A1, Pt. 8a-h
- Switch tractor’s hydraulics to control position.
- Attach implement to lower link and secure with linch pin.
Note
The attaching frame can be positioned horizontally by turning the
tilt spindle (11).
Doing this enables an easier coupling to the lower link.
Then turn the tilt spindle (11) back. See chapter „OPERATION“
also.
Pin upper link (1)
- Pin upper link (1) so that the attachment point (P1) on the plough
during operation is somewhat higher than the attachment point (P2)
on the tractor.
Securing lower link
If the tractor’s hydraulic control
is to be steered over the lower
link, then the upper link should
be positioned in the slot (LL) on
the attaching frame.
Securing upper link
If the tractor’s hydraulic control
is to be triggered over the upper
link, then both the (RL) borings
on the attaching frame are to be used.
- Couple hydraulic hoses to the tractor.
ST-24-11-2003
