0200-GB EINSATZ_987
GB
OPERATION
- 12 -
Setting the plough to the tractor using
"Servomatic"
„SERVOMATIC“ enables the optimum adaption of plough to tractor.
The following setting controls should be carried out in order.
1. Fine setting (F)
- Check setting measurement for fine adjustment spindle (F).
See chapter
"PRESETTING THE PLOUGH".
2.
Furrow width setting of the first ploughing component
(backfurrow)
The furrow width (S2) of the first ploughing component is set by turning
the spindle (VF).
Furrow width (S1) to narrow
- turn spindle (VF) longer
Furrow width (S2) to wide
- turn spindle (VF) shorter
Furrow width (S2) correct
- Spindle is correctly set according to table.
See chapter
"PRESETTING THE PLOUGH“
ncorrect setting
The drawing line does not run through the mid-point of the tractor’s rear
axle. Tractor is drawn into already ploughed area during ploughing. This
can only be compensated by steering in the opposite direction.
- Turn spindle (ZP) longer
See chapter
"PRESETTING THE PLOUGH“
3. Setting the drawing point (Z)
Correct setting
The drawing line (ZL) runs through the mid-point (M) of the
tractorʼs rear axle. No side pull arises from the tractor.
The plough is easy to pull.
- Spindle (ZP) is set according to the table.
See chapter
"PRESETTING THE PLOUGH“
F
B
A
W
165-02-11
12
3
1
4
2
SK
VF
ZP
165-02-12
