0200-GB EINSATZ_987
GB
OPERATION
- 13 -
Turning the plough over
Beware!
Nobody is to stand within the swinging range during turning.
Turning procedure is only to be actuated from the tractor cabin.
The plough must be completely raised to turn.
The automatic reversing gear enables the whole turning procedure to
be carried out through only one single switch position on the control
unit (ST).
Turning procedure with a double-action cylinder
- Switch control unit (ST) to lift (h).
The plough is turned 180¯.
- Switch control unit (ST) to neutral (O).
After some 5 seconds another turning procedure can be effected.
Setting the plough gradient (11)
The plough should sit as vertical (90°) as possible to the ground during
ploughing. This position is obtained by turning both spindles (11) as
described below.
- Lift plough 5 - 10 cm
- Actuate control unit (ST) briefly.
The plough turns slightly away from the stop spindle (11).
- Set the gradient using the spindle (11).
- Turn plough back to stop again.
- Proceed with ploughing and check whether the plough sits more vertically
(90°) to the ground through the new setting.
TD 65/92/48
s
h
0
ST
TD 65/92/25
90
°
