- 4 -
0800_GB-Power-control_5543
GB
PoWer conTrol - oPeraTion
3. Scraper floor forward run
As long as the button remains pressed
- the scraper floor runs at maximum speed for
-
ward towards the pick-up
- direction shown on display
2. Unload scraper floor / 2 phase motor
Briefly press button
- scraper floor is switched on or off
- Indication on display
- slow or fast
In the slow stage (tortoise)
- speed adjustment by continually pressing the button
"+" or "-"
In the fast stage
- Scraper floor runs at maximum speed
- speed indicator value remains
Stopping the scraper floor with the “STOP”
button
or “Scraper floor forward run”
Briefly cancellation of scraper floor back run when
- raising the pick-up
- opening the tailgate
- swinging cutters in
- lowering or setting up the forage top frame
- coupling the regulating rollers
- locking the trailing front axle
- mechanically engaging the cross conveyor belt
The scraper floor starts only when there are no other
hydraulic functions running
Note!
If the forage presses too strongly against the
regulating rollers, the scraper floor will stop
(roller pressure sensor). This will not appear
on the display.
For unloading the scraper floor can only be
started when the tailgate is open.
1)
only for wagons without cross conveyor belt or with standing cross conveyor belt
2)
only for wagons with cross conveyor belt
3)
only for wagons with regulating rollers
WORk menu unloading functions
1. Automatic unloader
Briefly press button
- automatic unloader is switched on or off
- activated automatic unloader appears on display
Advantages of the automatic unloader
- fast, efficient and even unloading
- minimum blockages in the feeder channel
- forage protection when unloading
Automatic unloader functional procedure
1. Open the tailgate
1)
Attention!
The tailgate is opened completely
2. Switch on cross conveyor belt
2)
3. Scraper floor is briefly switched to forward run
)
- Forage pressure on regulating roller is reduced
4. Switch on regulating rollers
)
5. Scraper floor carries out regulated unloading
If the “Close tailgate” button is briefly
pressed during
the unloading process:
- symbol blinks on display
- opened tailgate will slowly close
At this stage unloading is still not interrupted!
- If the tailgate reaches the lower area (approx. 10 cm
opening)
- scraper floor drive
- regulating rollers
- cross conveyor belt
are switched off.
- Hydraulics to close the tailgate will be triggered under
pressure.
- The tailgate is closed only when the symbol disappears
in the display.
Attention! The “Start automatic unloader”
function is activated only after a 0.8 sec
delay (safety precaution for road
transportation).
Take Care 3)
If the automatic unloader is started when
the p.t.o. is turned off, the warning indicator
“PTO” appears and a warning signal sounds
for 2 seconds. The automatic unloader waits
for 10 seconds for the p.t.o. to start before
the process proceeds or is interrupted.
