POSline SM2430, Руководство пользователя

Страница: 8 / 25

4
2. Insert the 8-pin modular plug of the power link cable into the “host” connec-
tor in the back of the scanner until a firm click is heard.
3. Plug the power adapter into the jack on the power link cable. (See Figure
1.)
4. Plug the AC end of the power adapter into an AC outlet. The scanner pow-
ers up, the buzzer sounds four beeps and the LED indicator glows blue.
5. Present a known-good test barcode to the scanner. The scanner should
issue a short beep and the LED should flash red momentarily. [If the scan-
ner is connected to a keyboard wedge for this test, it should read one bar-
code, beep, then remain with a red LED indicating light. This is normal
when the keyboard wedge is not connected to a live host terminal.]
Note: If the scanner does not produce any beeps, or produces the wrong
beeps, or the LED does not light, remove the power connection and refer to the
section on Troubleshooting.
4.3 Mounting
After the scanner passes its verification test ( Section 4.2 above), proceed with
mounting.
The scanner should be installed in a location away from direct sunlight; high
levels of ambient light reduce scanner effectiveness.
The two basic styles of mounting are a) with the included mounting plate, and
b) with a custom bracket (not included) for back mounting. If an auxiliary hand-
held scanner is to be attached, it must be properly connected as part of the
mounting process.