POSline SM2430, Руководство пользователя

Страница: 12 / 25

8
4.4 Connecting to the Host
The power link interface cable comes with different host-end connectors,
depending on the host. Follow the steps below to connect the interface cable to
the host.
1. Make sure that the power of the host system is off.
2. Connect the host end of the interface cable to the appropriate connector on
the host system.
3. For those cases where external power is used, plug the external AC power
adapter into the jack on the interface cable. (See Figure 1.)
4. Turn on the host system.
5 Setting Up the Scanner
In some cases no setup is required. The scanner is either pre programmed to
suit the situation, or it auto detects and is ready to go. In other cases the scan-
ner must be informed about what kind of system it is connected to. This can be
done in a few moments using the included booklet titled Programming Guide.
The Programming Guide may be used to set a number of parameters on the
scanner: communication interface type (RS-232, Keyboard, USB), beep tone,
sleep mode timings, same-code delay time, enable/disable decoding of numer-
ous code types, and more advanced things like set headers and trailers.
Individual parameters may be set at any time without affecting the other param-
eters.
5.1 Scan Test
1. With the scanner running (LED blue) and the host system on, try to scan
several known-good barcodes.
2. Check the results on the POS screen. If the scanner is reading okay, no fur-
ther setup may be necessary.
3. If the POS screen does not show the expected scans, go to Set Up, below.
5.2 Set Up
1. With the scanner running (LED blue) and the host system on, present the
<Enter/Exit Programming Mode> barcode, found on the inside cover of the