Page 19
over hardware signals that can be detected by the host as “DSR” or “CTS”.
SW3 software switch works as following:
Switch
position
ON
OFF
1
Raster Bitmap Print by line print.
Raster Bitmap Print by buffer batch.
2~4
Printing Speed regulate.
5~8
Print Density Adjust
For switch position 3-1, it defines the printing behavior of the printer on
graphic printing. When it is set to ON, the printer prints on each printing
command received immediately. However, the printer may have to engage
brake frequently waiting for next command resulting in trembling. When this
switch is set to OFF, the printer starts printing only when more graphical data
are collected thus performing a much smoother printing operation.
Effect of positions 2, 3&4 on Printing Speed is defined as below:
SW3 Pos. 2
OFF
ON
OFF
ON
OFF
ON
SW3 Pos. 3
OFF
OFF
ON
ON
OFF
OFF
SW3 Pos. 4
OFF
OFF
OFF
OFF
ON
ON
Printing Speed
300
mm/sec
280
mm/sec
250
mm/sec
220
mm/sec
200
mm/sec
180
mm/sec
Please notice when system recognizes barcode will be printing, the speed will
automatic set to 180mm/sec to ensure these barcode prints perfectly.
Effect of positions 5, 6 & 7 on Print Density is defined as below:
SW3 Pos.5
OFF ON
OFF ON
OFF ON
OFF ON
OFF ON
OFF
SW3 Pos.6
OFF OFF ON
ON
OFF OFF ON
ON
OFF OFF ON
SW3 Pos.7
OFF OFF OFF OFF ON
ON
ON
ON
OFF OFF OFF
SW3 Pos.8
OFF OFF OFF OFF OFF OFF OFF OFF ON
ON
ON
Print
Density
100% 105% 110% 115% 120% 125% 130% 95% 90% 85% 80%
Since the qualities of different paper are not alike, please regulate the print
density and printing speed to obtain the satisfaction of printing quality.
SW4 software switch works as following:
Switch
position
ON
OFF
1
Available “Beep” sounds after printing. Disable “Beep” sounds after printing.
2~3
Barcode Height Reduction.
4~5
Line Space Reduction
6~7
Line Feed Reduction
8
Set Hardware Switch 1 Invalid
Set Hardware Switch 1 Valid
