Page 17
Printable
Width
512dot 576dot 424dot 432dot 512dot 576dot 640dot 640dot
For switch position 6, switch to “ON’ when use USB interface. For other
interface such as Serial, Parallel, LAN and Wi-Fi, please place the switch to
“OFF”.
Switch position 7 defines the auto cutter. When needs to enable the paper auto
cut function, it have to place to “Off”. On the other hands, the auto cutter
function will disable when it place at “On”.
Switch position 8 defines the firmware update function. If the printer needs to
update the firmware, please set to “ON” position. In order to operating
perfectly, please set in “OFF” when the printer do not needs to update the
firmware or in normal situation.
The factory default for each position listed as below:
Switch 1 Position
1
2
3
4
5
6
7
8
Default setup for Aura-
9000
OFF
ON
OFF OFF OFF OFF OFF OFF
Software switch
Another method to setup Aura-9000 series is through the software switch
setting, which means other functions must be change by software utility.
Please visit our web site
http://www.posiflex.com
or
http://www.posiflex.com.tw
to download the
Aura-9000 software switch
utility.
Software switches has divided into
SW1,
SW2
,
SW3 and SW4
.
Following information is going to describe these settings.
SW2 software switch works as following:
Switch
position
ON
OFF
1
Paper Back Feed Disable.
Enable Paper Back Feed.
2
Disable paper auto-cut at top cover
close.
Enable paper auto-cut at top cover
close.
3
Full-cut mode.
Partial-cut mode.
4
Cut without paper feed
Cut with auto paper feed
5
Busy on “buffer full”
Busy on “buffer full” and/or “off line”
6
CR code (0Dh) effective
CR code (0Dh) invalid
7
Even parity
None parity
8
XON/XOFF handshaking
DSR/DTR handshaking
Software switch 2-1 controlled the retractable function. When this switch set to
OFF, printer will enable to retract paper 14.5 mm before it start to print with
the aim of reduce paper loss. In contrast, it will straight to print when this
switch place to ON. Please notice that the factory default of this switch is OFF.
