POSEIDON PE 100-T, Инструкция по эксплуатации

Страница: 33 / 46

Instruction Manual
w
PE 100-T
27
4.5. TROUBLE-SHOOTING
Trouble Cause Remedy
Drive motor (electric)
Motor will not start Electric circuitry faulty Check all fuses, terminal connections,
wire leads, make sure that motor data
complies with mains supply
Motor/engine runs eccentrically V-belt worn Replace
Motor protection switch is switching
off the unit Wrong adjustment of the motor pro­
tection switch Set to nominal motor current. Observe
temperature compensation (+20
°
C
=1,0)
For ambient temperature
+ 10
°
C : correction factor 0,94
+ 30
°
C : correction factor 1,05
+ 40
°
C : correction factor 1,12
Unsufficient voltage because of weak
power supply Switch off other consuming devices
Motor protection switch is switching
off the unit Power supply cable to long or to thin Use suitable cable
Drive motor (petrol)
Motor will not start See motor instructions See motor instructions
Motor runs eccentrically V-belt worn Replace, see chapter 4.4.10.
Motor stops Low oil level Top up oil
Drive system
Excessive v-belt wear (black deposits
on belt guard)
V-belt tension Re-tighten, see chapter 4.4.10.
Pulleys not aligned Re-adjust, see chapter 4.4.10.
Compressor
Compressor does not attain final pres­
sure Condensate drain valve(s) leaking Tighten and reseal
Final pressure safety valve defective
(blows too soon) Replace safety valve
No cartridge in filter system P11 (air
escaping through cartridge safety
bore) Replace cartridge, see chapter 4.4.4.
Vent screw for final pressure safety
valve not in operating position To vent, unscrew until completely
open, see chapter 4.4.7.
Air delivery drops
Intake filter soiled Clean or replace filter cartridge, see
chapter 4.4.2.
Pipe coupling leaking Retighten couplings
Excessive wear of 3rd stage piston Replace piston and sleeve of 3rd stage
Intermediate pressure safety valve
blows Intermediate pressure too high be­
cause of defective inlet or pressure
valve of the following stage Check/replace inlet or pressure valve,
see chapter 4.4.9.
Safety valve leaking Replace safety valve
Compressor overheats
Insufficient cooling air Check location; ensure proper cooling
air flow, see chapter 3.1.
Ambient temperature too high Check location; ambient temperature
max. +45
°
C (113
°
F), see chapter
3.1.
Direction of rotation is wrong Correct direction of rotation
Inlet and pressure valve of one stage is
leaking Check valves, clean/replace if neces­
sary, see chapter 4.4.9.
Taste of oil in the air
TRIPLEX cartridge saturated Replace cartridge, see chapter 4.4.4.
Unqualified lubricant being used Replace oil with an approved brand,
see Lubricating oil list in annex.