POSEIDON PE 100-T, Инструкция по эксплуатации

Страница: 22 / 46

Instruction Manual
w
PE 100-T
16
OIL PACKAGES
BAUER compressor oil is available in various quantities,
refer to oil list in chapter 8.
OIL CHANGE
- Run compressor warm.
- Remove oil dipstick.
- Drain oil while still warm by means of oil drain plug. Re­
place the sealing, reinstall drain plug and tighten well.
- Refill with oil through the oil filler neck.
- Oil level is checked with oil dipstick, oil level is correct if
at upper mark.
Fig. 16 Oil dipstick markings
min.
max.
CHANGING THE OIL TYPE
To avoid severe damage to the compres­
sor unit when changing the oil type, the
following measures should be strictly ad­
hered to:
− Drain oil completely while still warm.
− Check valves, coolers, separators, purifiers, and all
pneumatic tubes and hoses for deposits.
If deposits are detected, perform the following:
− Change or clean valves, coolers, separators, purifi-
ers, and all pneumatic tubes and hoses from depos-
its.
− Fill compressor with the new oil.
− After approx. 100 operating hours check lubricating
oil for degree of contamination, and change oil again
if necessary.
− Top up compressor and perform subsequent oil
changes with same oil, only.
4.4.2. INTAKE FILTER
DESCRIPTION
A dry micronic filter is used to filter intake air (Fig. 17).
Fig. 17 Intake filter
1 Knurled nut
2 Plastic cap
3 Micronic filter cartridge
4 O-ring
5 Opening
5
4
3
2
1
INTAKE FILTER MAINTENANCE
Filter cartridge must be changed at regular intervals accord­
ing to schedule in the service booklet.
- Remove knurled nut (1) and take off plastic cap (2). Re­
move filter cartridge (3).
- Clean filter housing inside with a damp cloth. Take care
to prevent dust from entering intake pipe.
- Replace O-ring (4) if damaged.
- Insert a new filter element and fasten with cap and nut.
TELESCOPIC INTAKE TUBE
The telescopic intake tube has to be inserted in opening 5,
Fig. 17. It is necessary to ensure clean air. Petrol driven
breathing air compressor units are fitted with a telescopic
intake tube supplied with the unit. The use of it is also rec­
ommended for electric power driven units.