ēno play
3. Select the template location that is appropriate for your installation based on the instructions
you see on the template.
4. Using an alcohol wipe, clean the area about 3” (76mm) below the correct template location.
5. Orient the driver pack with the wires facing the floor.
Note
: Use care when mounting the amplifier and driver packs to the back of the whiteboard.
The supplied adhesive is intended to be permanent. If you need to remove or reposition the
components, additional supplies are provided. Refer to “Removing and replacing the cable tie
holders, driver packs or amplifier”.
7. Position the driver pack against the template without touching the adhesive to the board or
touching the adhesive with your fingers.
Important Note
: Make sure the registration is correct before proceeding.
14 of 38
2002480-001 Rev C
Installation and Operation Guide