- 26 -
GB
1201_GB-Allgemeine-Wartung_BA
Parking in the open
When parking in the open for
long periods of time, clean piston
rods and then coat with grease.
FETT
TD 49/93/2
Safety points!
• Turn engine off
when ad ju st ment,
service and repair
work is to be
done.
• Do not work under
the machine wit-
hout safe support.
• Retighten all
screws after the
first hours of
operation.
• Only place the
machine on an
even, firm ground.
Cleaning of machine parts
Attention! Do not use high-pressure washers for the
cleaning of bearing- and hydraulic parts.
- Danger of rust!
- After cleaning, grease the machine according to the
lubrication chart and carry out a short test run.
- Cleaning with too high pressure may do damage to
varnish.
Safety point
• Turn engine off when ad ju st ment, service and repair
work is to be done.
Hydraulic unit
Caution! Danger of injury or infection!
Under high pressure, escaping fluids can penetrate the
skin. Therefore seek immediate medical help!
Make sure that the hydraulic system is suitable for the
tractor before connecting the hydraulic lines.
After the first 10 operating hours and then every
consecutive 50 operating hours
- Check the hydraulic unit and lines for tightness and
retighten screw connections if necessary.
Before operation
- Check hydraulic hoses for wear.
Replace worn or damaged hydraulic hoses immediately.
The replacement hoses must meet the manufacturer’s
technical requirements.
Hose lines are subject to natural ageing. The period of
use should not exceed 5 – 6 years.
Winter storage
- Thoroughly clean machine before storage.
- Put up protection against weather.
- Change or replenish gear oil.
- Protect exposed parts from rust.
- Lubricate all greasing points according to lubrication
chart.
Drive shafts
- see notes in the supplement
For maintenance please note!
The instructions in this operating manual are always
valid.
In case there are no special instructions available, then
the notes in the accompanying drive shaft manufacturer´
instructions are valid.
Repair Instructions
Please refer to
repair instructions
in supplement (if
available)
Safety points!
Clean the hydraulic
line couplings and
the oil connec-
tions each time
before coupling.
Check for chafing
and jamming
points.
MAINTENANCE
General maintenance hints
In order to keep the implement in
good condition after long periods of
ope ra ti on, please observe the following
points:
- Tighten all screws after the first
hours of operation.
In particular check:
- blade screws on the mowers
- tine screws on the swather and tedder.
Spare part
a. The original components and accessories have been
designed especially for these machines and appliances.
b. We want to make it quite clear that components and
accesories that have not been supplied by us have not
been tested by us.
c. The installation and/or use of such products can,
therefore, negatively change or influence the
construction characteristics of the appliance. We are not
liable for damages caused by the use of components
and accessories that have not been supplied by us.
d. Alterations and the use of auxiliary parts that are not
permitted by the manufacturer render all liability invalid.
Содержание NOVACAT 225 H
Страница 20: ... 20 0400 D ROTOR_377 ...
Страница 36: ...GB Anhang Titelblatt _BA Allgemein GB SUPPLEMENT ...
