Plus NF-20, Руководство пользователя

Страница: 7 / 54

E-7
Names of the Parts
CAUTION
• At least two persons should hold the main unit. If not, the main unit could drop or tip, resulting in accidental injury.
• Lock the stand’s casters by pressing the bottom of the caster lock button. If not, the stand could move while the main
unit is being mounted or removed, resulting in accidental injury.
• After unplugging the power cord from the wall power outlet, disconnect all the connection cords from the set’s input/
output terminals. If the set is removed without disconnecting the cords, it could tip, resulting in accidental injury.
• If a printer is mounted on the set, remove the printer before starting. If not, the stand could tip while the main unit is
being mounted or removed, resulting in accidental injury due to the printer dropping or tipping over.
How to change the height and angle of the stand (sold separately)
These adjustments are required when installing the main device on a stand sold separately. The device
can be set at a height of 1650 mm or 1850 mm and at an inclined angle of 0, 7 or 10 degrees.
（ 1 ） Disconnect the power plug from the power
socket on the wall and disconnect all cables
connected to the main body.
（
2
）
Remove the securing knobs (two on the left
and right)
（
3
）
Remove the grommet (two on the left and
right).
（
4
）
Switch the mounting hole positions on the left
and right of the main body.
Lift up the main body by about 1 cm to release it
from the hook.
Hang the main body on the stand by mounting
the holes (two on the left and right) of the main
body fully onto the hooks on the stand.
The height of the mounting hole at the top will be
1650 mm while the height of the mounting hole at
the bottom will be 1850 mm.
（
5
）
Fix and tighten the securing knobs to the
screw holes of the two angle adjustment
fittings on the left and right of the main body.
At this point, the inclination angle of the copy
board will change depending on the screw
holes selected.
（
6) Insert into the screw holes (two on the left and
right) used for the securing knobs where the
grommets are no longer used.
(7) Connect the various connection wires.
* This illustration does not show the connection cords.
Mounting hole for the securing knob when setting at a height of 1850 mm
0 degrees
0 degrees
10 degrees
10 degrees
Angle adjustment fitting
7 degrees
7 degrees
Mounting hole for the securing knob when setting at a height of 1650 mm
Main Body
For 1650 mm use-
Mounting holes
For 1850 mm use-
Mounting holes
Angle adjustment
fitting
Mounting holes
Hook
Securing knob
Grommet
Stand