Plockmatic MPS XL, Руководство по эксплуатации

Страница: 25 / 44

25
3
Setting Sheet Guide & End Stop (continued)
Sheet Guide Height Knobs
Sheet Guide
9. Loosen Sheet Guide Height Knobs (2x) and move them down so they are at or
slightly below the level of the Stacker Table. See that the Sheet Guide now rests on
the Stacker Table and can move up and down freely.
10. With paper still on Stacker Table set Sheet Guide to correct width +3mm to 5mm
(+0.12’’ to 0.20’’) on each side.
11. Replace Paper Support at the closest point to the Sheet Guides & End Stop
(Section 1 - Setting the Paper Support).
12. Tighten all knobs.
13. Remove paper used for setup.
*Recommendation: Start with all guides set loosely around the paper and then
tighten as the job has began to run Guides set too narrow will result in jams.