Plockmatic MPS XL, Руководство по эксплуатации

Страница: 18 / 44

18
2
Software version
Software version
The software version is displayed through
the LEDs: Switch the Stacker on. Set the
Fan Adjustor to illuminate 1 dark blue
Indicator LED. Press and hold the Pause/
Resume Button until the light turns purple
(approximately 5 seconds). The top three
LEDs will blink in purple to show the
software version installed on the Stacker.
Then the top three LEDs will blink in yellow
to show the software version installed on
the Docking Bracket.
The number of blinks represents the
software version as explained below:
• Light 1: X
• Light 2: Y
• Light 3: Z
Version of the software: X.YZ
Light 1
Example
:
Light 1 blinks once, light 2 blinks twice and
light 3 does not blink: the version of the
software is 1.20.
Fan speed adjustment
Fan speed adjustment
Fan speed changes how the papers are
stacked and helps cool the stack.
The fan speed adjustment dial allows
the operator to control fan speed when
running.
• Auto - printer controlled from inputted
paper size and line speed. The
operator can set a higher/lower
fan speed by adjusting fan speed
adjustment dial.
• Manual increments - operator
controlled between minimum - 0% to
maximum - 100%.
Manual recommendations:
• Lighter media - reduce fan speed.
• Heavier media, speciality film or with
large area coverage print - increase
fan speed.
NOTE:
When running, LED bar displays Fan
speed.
Continued on next page...
Auto
20%
30%
40%
50%
60%
70%
80%
90%
100% Dark Blue
Green
Light Blue
Dark Blue
Light Blue
Dark Blue
Light Blue
Dark Blue
Light Blue
Dark Blue
Fan
Adjustor
Pause/Resume
Button
0%
Au
to
.2
0%
...
|...
...|..
....|......|....
..|..
....
|....
..|..
...10
0% 0%
Au
to
.2
0%
...
|...
...|..
....|......|....
..|..
....
|....
..|..
...10
0%