20 September 2006, Rev 0.01
3-36
3.4.20 FOLD STOP
ASSEMBLIES
It is most important that the fold stop is parallel and have the right distance to the
clinchers.
1. Remove trimmer unit if any (
1.4.4).
2. Ensure that all teeth are in line at the fold stop. Check with a scale or similar.
3. Set the machine to A3 or 11”x17”.
4. Check that following settings is set to 0,0 mm.
Staple On Fold: 0,0mm
Staple Fold Pos: 0,0mm
5. Hand feed two sheets into the machine and check the book.
6. If the book is skewed the fold stop must be adjusted.
7. Loosen the four screws [A], two on each side ( x4 ).
8. Adjust with the two adjusting screws [B] ( x2 ).
9. Repeat the adjustment until the book is not skewed.
10. Check that the staples are centred right over the fold line.
11. If not both screws [B] must be adjusted equal.
12. Tighten the screws [A].
[A]
[B]
Continued on next page....
outfeed view
