20 September 2006, Rev 0.01
3-30
3.4.14 SIDE JOGGER CHANNELS, CONTINUES
4. Turn the timing belt pulley on the side jogger motor M4 so the side jogger
channels touch the edges of the paper or template.
5. If the side jogger channel isn’t parallel to the paper or template it has to be
adjusted.
6. Loosen two screws [J], on the side jogger mounting bracket ( x2 ).
7. Turn the timing belt pulley on the side jogger motor M4 so the side jogger
channels touch the edges of the paper or the template.
8. Tighten the screws [J] ( x2 ). Check again.
9. Mount the side jogger channel extensions [H] and turn the pulley on the motor
again.
10. Turn the timing belt pulley and check that the lowest point at the side jogger
extension is parallel to the side jogger channel.
11. If not, loosen the two nuts [K] and adjust it to be parallel (
x2 ).
Adjustment, height
There should be a 1-2 mm distance [L] between the side jogger channels and the
roller bracket [M]
1. Remove the side jogger channel [D].
2. Adjust the height by turning the screws [G]. Both screws on each side should
be adjusted within 0,5 mm. One turn on the screws equals 0,7 mm. Turning
clockwise decreases the space between the side jogger channel and the roller
bracket.
3. Install the side jogger channel.
[L]
[M]
[D]
ASSEMBLIES
