20 September 2006, Rev 0.01
3-32
3.4.16 REAR JOGGER ALIGNMENT
ASSEMBLIES
Purpose
The jogger fingers [A] must be parallel with the trail edge of the paper.
Adjustment
1. Set the machine to A3 or 11”x17”.
2. Enter service mode. Motors.
3. Open the top cover and insert the interlock cheater.
4. Insert an A3 or 11”x17” paper in the stapler area against the stop gate.
5. Run back jogger motor M2 “Up” position.
6. Run back jogger poisoning motor M3 “Cycle2” (down) until the jogger fingers
touches the paper. Continue to run approximately 5 mm (The paper will curl).
7. Run M3 “Cycle1 ((up) until the fingers are leaving the paper. All fingers should
leave the paper (parallel to the paper) at the same time.
8. If the fingers are not parallel to the edge of the paper loosen the 4 screws [B]
(
x2 ). Adjust the bracket until fingers are parallel to the edge of the paper.
9. Check that the distance between the in-feed belt roller and the paper [C] is 3-4
mm. If that distance could not be obtained the in-feed roller bracket must be
adjusted. The screws are placed under the roller.
[A]
[C]
[B]
