Replacement
Adjustment
20 September 2006, Rev 0.01
3-31
ASSEMBLIES
3.4.15 REAR JOGGER FINGERS
Removal
1. Run M3 in service mode down to the home switch.
2. Remove in-feed module (
3.4.1 ).
3. Snap out the link between the motor and the jogger assy [A] at the jogger assy .
4. Loosen screws [B], one at each side of the shaft ( x2 ). Only one screw is
shown.
5. Lift out the shaft assy.
6. Remove the jogger fingers.
7. Remove the nuts [C] (
x4 ).
8. Remove the plastic washer [D] and the bearing [E] on the outer fingers (
x1 ).
9. Replace jogger finger assembly [F].
Installation
1. Use new plastic washers for the outer fingers.
2. Don’t tight the nuts to hard which can make it bind on the shaft. Plastic bush-
ings must move freely on the shaft.
[A]
[B]
[C]
[C]
[F]
[E] [D]
