Platinum Curve Stairlift, Руководство по установке, Страница: 39 / 44

39
Servicing
The Standard 120 Kg (19 stone) stairlift requires a service every 12
months.
The Heavy Duty 160Kg (25 stone) stairlift reqires a service evey 6 months.
Items listed below should be checked and renewed if necessary.
If pinion and/or main load roller need replacing, you will require an 3 legged
bearing puller to remove pinion and cam.
When reassembling, ensure pinion and cam keys are inserted and aligned
correctly. The pinion/cam must be wound or pressed back into place.
Hammering will break motor/gearbox oil seals and void warrenty.
When replacing the circular, free spinning pinion guard, the bolt must be
re-fit using using loctite type 272.
Services should only be carried out by a competent stairlift engineer.
Service Carriage
Remove carriage from rail. Turn off.
1. Top Skate. Remove all skate covers .

Check rollers for wear/damage. To renew rollers, remove 17mm bolts
discard old rollers, lubricate bolt shafts
lightly , and fit new rollers. The
bolts must be replaced using loctite type 272 (or local equivelant) and
tightened to 40NM.

Check all rollers rotate freely.

Check all yokes rotate freely.

Check skate swing arm rotates freely and there is no excessive front
to back play.

Check all wires and connectors for damage & and operation of all
switches.

Remove any debris and clean all surfaces.

Replace all covers ensuring spacers, springs and nuts are all present
and correct. Check operation of safety edges.
2. Bottom Skate. Remove all skate covers.

Check rollers for wear/damage. If replacing, lubricate roller shafts
lightly.

Check pinion for wear/damage.

Check pinion guard rotates freely.

Check all rollers rotate freely. If necessary lubricate roller shafts
lightly.

Check bottom skate revolves freely to limit of wiring loom on drive
shaft. (If action feels notchy this could be an indicator of bearing
damage.

Check bottom skate moves freely along drive shaft. Lubricate if
necessary.

Check all wires and connectors for damage & and operation of all
switches.

Check operation of OSG and safety gear. Pay close attention to
condition of large main load roller.

Check operation of charge pin and final limit switch.