Platinum Curve Stairlift, Руководство по установке, Страница: 17 / 44

17
Place the stepped rubber divider
on the bottom of the battery
compartment.
Place the first battery vertically in
the compartment with the terminals
at the top, facing towards you.
Place the flat rubber divider on to
of the battery and then place the
second battery on top of the first
vertically in the compartment with
the terminals at the bottom, facing
towards you.
Connect the black lead to the
–ve
(black) terminal of the top battery
and connect the red lead to the
+ve (red) terminal of the bottom
battery. Connect the fused link
between the remaining
–ve (black)
and +ve (red) terminals as shown
in the picture.
Once the batteries are fitted and connected the plastic front, and battery
side carriage cover can be replaced. Ensure that cables for the Diagnostic
Display and, if fitted, the powered swivel are connected correctly.
Leave the PCB side cover off until later in the installation process.
As the batteries will enable the correct operation of the electro magnetic
brake, the carriage can be hand-wound completely onto the track using the
instructions printed on the plastic cover adjacent to the Hand Winding
Socket (5).
Tip.
If the grey, final limit circuit is completed the carriage can now be operated using the
remote controls. To complete the circuit, bridge the two grey wires in the chair loom
connector located in the center of the swivel boss on top of the carriage.