Plastimo 68756, Инструкция по эксплуатации

Страница: 65 / 376

65
DSC OPERATION
■
MMSI Code Programming
The 9-digit MMSI (Maritime Mobile Service Identity: DSC self ID) code can be programmed by PC
software and also manually set on this transceiver.
1. Press and hold [PWR] knob to power ON.
·
Three short beeps sound, and “ Push [OK] to Register your MMSI ” is displayed.
2. Press [OK] to start setting the MMSI code.
·
During the setup process, press [BACK] to skip the setting and return to normal operating mode,
and you cannot make a DSC call.
3. Enter the MMSI code:
·
Press [
◄
]/[
►
] to select the desired number.
·
Press [OK] to input the selected number.
·
Select
“←”
or
“→”
, or rotate [DIAL] to move the cursor, then press [OK].
4. Repeat step 3 to enter all 9 digits.
5. After 9 digits have been input, press softkey [ ] to set the code.
6.Enter MMSI code again to confirm.
7. Repeat step 3 to 5 as above.
·
When your MMSI code is successfully input, “ MMSI Successfully Registered ” is displayed as
below.
·
After setting, this transceiver can perform normal operation.
NOTE:In the menu interface, you can query the set MMSI code.
■
ATIS ID Programming
The Automatic Transmitter Identification System (ATIS) ID consists of 10 digits. You can enter the ATIS
ID in the
“ ATIS ID Input ” item on the Menu screen.