Planar Dome Md5/PCI, Руководство по установке

Страница: 41 / 150

Installing the Md5/PCI Board in a PC 29
4. Secure the mounting bracket with the bracket screw.
5. Remove a blank bracket from the back of the slot you
choose for the VGA output.
6. Insert the VGA bracket and secure the mounting
bracket with the bracket screw.
7. Attach the VGA monitor to the 15-pin connector.
8. Replace the system unit cover.
Installing multiple boards
To install multiple boards, repeat the installation instruc-
tions in “Installing the Board in a PC” on page 21 for
each board.
• Each board requires less than 3 amps of +5V.
• You can install as many Md5/PCI boards as your sys-
tem’s power supply and available PCI slots can support.
• You must disable VGA mode on all but one DOME
board if multiple boards are in use. See “To disable VGA
mode” on page 26.
If you are not supporting VGA with the DOME board,
go to step 8.
Unless your system contains card-retention hardware,
you must remove the Md5/PCI board from your
system before shipping. Otherwise, you may cause
damage to the board.
Tips
Remember these tips when you are installing multiple
boards: